In case you want to become a emergency service through apprenticeship, you will have to approach the local plumber's union, who can help you to find a professional plumber willing to hire an apprenticeship.
There are two, one on each side of the toilet, closet bolts which hold the toilet to the floor. If there are caps over the bolts, remove or pop them open. Using a small crescent wrench unscrew the nuts from the bolts. Alternate side to side when unscrewing this will be much more important when reinstalling the water line repair bolts but alternate anyhow.
If you need to add copper pipe make sure that you clean the old and new pipe by using sandpaper, inside and out. If it's not clean the solder will not flow into the joint. Another tip is to not over wrap the mail threaded pipe with tape, this can cause a leak. Twice around should be enough. Also, don't over tighten it.
The location of a plumbing contractor is a key factor. This is because he or she will not only charge you an hourly rate, but travel costs will also be charged. This can add a significant amount to the final bill if the contractor has to travel from the other side of town.
Here are some general cautions. Do not begin jobs on holidays, weekends, or at times when plumbers raise their rates or are difficult to reach. Do start early leaving plenty of daylight to call a plumber if something goes wrong. Study the situation carefully. Think about what might happen if something suddenly broke and what the effects would be. Old corroded copper tubing might break in the wall when you are wrenching an angle stop that supplies the water line repair to your toilet. A flood in the wall could be costly. If the angle stop, on the other hand, is new and shuts off easily and you have another toilet in the house then it might make sense to repair the toilet yourself. Be honest, too. Are you handy with tools? Did you do well in shop classes in school?
For a newly installed icemaker, you will need up to 24 hours to let the machine function and cool down. A newly installed icemaker may not work until the ice mold temperature has dropped to about 15F - 16F degrees. If you have just added a water line to the refrigerator, it may take up to about an hour and a half for the machine to start working. Also, a newly installed water line may have air in the line. It can sometimes take a few ice making cycles to clear the line of air.
Once you've located the water shut off, turn it off. Now, you can turn your attention to trying to contain the water damage caused by any leaking. Get towels, fans, blankets, or anything else to try and sop up water that is sitting on carpet or wood floors. Linoleum floors usually don't undergo much damage from having water sitting on them, unless there are cracks in the linoleum (often invisible) where the water can seep in. When your Queens plumber arrives, you will be one step ahead by following these instructions.